53. Water Pump Installation

Water Pump Installation

Prior to installing the water pump, read the entire procedure. Pay special attention to avoid part damage and to ensure proper sealing.





1. Install the water pump assembly (1).

2. Install the water pump bolts. Finger tighten the bolts.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Tighten the water pump bolts to 25 Nm (18 lb ft).

4. Apply sealant to the water pump drain plug. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

5. Install the water pump drain plug, if necessary. Tighten to 20 Nm (15 lb ft).





6. Install the water feed tube (1).

7. Lubricate the feed tube O-ring with antifreeze.

8. Install the water feed tube by twisting and pushing toward the water pump. Take care not to tear or damage the O-ring.

9. Install the thermostat housing (2) to block bolts and stud and tighten to 10 Nm (89 lb in).





10. Install the engine coolant temperature sensor (1) by hand.

11. Tighten the engine coolant temperature sensor and tighten to 20 Nm (15 lb ft).