Stop Lamp Switch Replacement (With Adjustable Pedals)

Stop Lamp Switch Replacement (With Adjustable Pedals)

Removal Procedure

1. Apply the park brake.
2. Remove the driver knee bolster. Refer to Knee Bolster Replacement (Cadillac) ()Knee Bolster Replacement (Except Cadillac) ().
3. Disconnect the stoplamp switch electrical connector.




4. Remove the power vacuum brake booster pushrod retainer bolt (1).




5. Remove the power vacuum brake booster pushrod retainer (1).




6. Slide the power vacuum brake booster pushrod off of the brake pedal pin and remove the stoplamp switch (1).

Installation Procedure




1. Install the stoplamp switch (1) to the power vacuum brake booster pushrod.
2. Install the power vacuum brake booster pushrod with the stoplamp switch to the brake pedal pin.




3. Install the power vacuum brake booster pushrod retainer (1).
4. Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.





Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the power vacuum brake booster pushrod retainer bolt (1) and tighten to 10 Nm (89 lb in).
6. Connect the stoplamp switch electrical connector.
7. Install the driver knee bolster. Refer to Knee Bolster Replacement (Cadillac) ()Knee Bolster Replacement (Except Cadillac) ().