Less than 3900 kg (8600 lb) GVW

ABS Indicator Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The instrument panel cluster (IPC) illuminates the antilock brake system (ABS) indicator during the IPC bulb check or when the electronic brake control module (EBCM) detects a fault and sends a serial data message to the IPC commanding the indicator ON.

Reference Information
Schematic Reference

Antilock Brake System Schematics Less than 3900 kg (8600 lb) GVW
Connector End View Reference

Component Connector End Views Connector Views
Description and Operation

ABS Description and Operation ABS (Greater than/Equal to 3900 kg (8600 lb) GVW)
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON, with a scan tool command the IPC display test ON and OFF. The ABS warning indicator should turn ON and OFF.

• If the ABS warning indicator does not turn ON and OFF, replace the IPC.

2. Replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for IPC and/or EBCM replacement, setup, and programming