Steering Linkage Inner Tie Rod Replacement (Standard)
Steering Linkage Inner Tie Rod Replacement (Standard)
Removal Procedure
Note: After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.
1. Remove the steering gear boot. Refer to Steering Gear Boot Replacement (HP2) Steering Gear Boot ReplacementSteering Gear Boot Replacement (Without HP2) Steering Gear Boot Replacement.
Caution: Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
Caution: The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe wrench in any other location will cause damage to the steering gear.
2. Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).
3. Place a wrench on the flats of the steering linkage inner tie rod (2).
4. Rotate the steering linkage inner tie rod (2) counterclockwise, while holding the steering gear rack stationary, until the steering linkage inner tie rod separates from the steering gear rack (1).
Installation Procedure
Note: All threads must be clean prior to LOCTITE(R) application. Check the LOCTITE(R), or equivalent, container for the expiration date. Use only enough LOCTITE(R) to evenly coat the threads.
1. Apply LOCTITE(R) 262, or equivalent, to the steering gear inner tie rod threads.
2. Attach the steering linkage inner tie rod onto the steering gear rack.
3. Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).
Caution: Refer to Fastener Caution Fastener Caution.
4. Tighten the steering linkage inner tie rod (2).
Tighten the steering linkage inner tie rod to 150 Nm (111 lb ft).
5. Install the steering gear boot. Refer to Steering Gear Boot Replacement (HP2) Steering Gear Boot ReplacementSteering Gear Boot Replacement (Without HP2) Steering Gear Boot Replacement.