Assist Step Replacement (Power BRS)

Assist Step Replacement (Power BRS)












2.Mark the location of the front T-slotted bracket and measure to the front of the assist step with a grease pencil and tape measure.

3.Transfer the measurement to the new assist step with the grease pencil and tape measure.

4.Mark the location of the rear T-slotted bracket and measure to the rear of the assist step with a grease pencil and tape measure.

5.Transfer the measurement to the new assist step with the grease pencil and tape measure.

1Power Assist Step Bolt (Qty: 4)
Caution:Refer to Fastener Caution .
Tighten 12 N �m (106 lb in)

2Power Assist Step
Important:It is essential to make the measurements in the preliminary procedures or the power assist steps may not be aligned to the body properly.
Tip Transfer any parts as needed.