Driver or Passenger Seat Back Cushion Finish Panel Replacement

Driver or Passenger Seat Back Cushion Finish Panel Replacement

Removal Procedure





1. Pull the seat back cushion cover and pad back (1) with your thumb to locate and gain access to the clip tower.





2. Using a flat bladed tool (1) from one side of the seat, slide the tool inward and horizontally on the seat back frame until the clip is caught.





3. Push the flat bladed tool (1) inward prying the clip out of the seat frame back, while gently pulling rearward at the top of the panel.





4. Release the other clip retainer on the opposite side.

5. Lift the panel (1) upward to remove it from the seat.

Installation Procedure





1. Install the rear seat back cushion panel (1) by inserting the lower clips over the seat back frame.

2. Push the upper two clips into the seat back frame until the panel is secure.