Upper Intermediate Steering Shaft Replacement

Upper Intermediate Steering Shaft Replacement

Special Tools

J 42640 - Steering Column Anti-Rotation Pin

Removal Procedure





Caution:
With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:

* The steering column

* The intermediate shaft(s)

* The steering gear

After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.

1. Install the J 42640 - steering column anti-rotation pin in the steering column lower access hole.

2. Remove the intermediate shaft bearing. Refer to Intermediate Steering Shaft Bearing Replacement Intermediate Steering Shaft Bearing Replacement.





3. Remove the upper intermediate shaft (2) to steering column retaining nut and bolt (1).

4. Disconnect the upper intermediate shaft from the steering column and remove the upper intermediate shaft.

Installation Procedure





1. Install the upper intermediate shaft and connect the upper intermediate shaft to the steering column.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the upper intermediate shaft (2) to steering column retaining nut and bolt (1) and tighten to 62 Nm (46 lb ft).





3. Install the intermediate shaft bearing. Refer to Intermediate Steering Shaft Bearing Replacement Intermediate Steering Shaft Bearing Replacement.

4. Remove the J 42640 - steering column anti-rotation pin from the steering column lower access hole.