Body Side Window Replacement (Stationary)

Body Side Window Replacement (Stationary)

Special Tools

* J 24402-A - Glass Sealant Remover (Cold Knife)

* J 39032 - Stationary Glass Removal Tool

* Use a urethane adhesive system which meets GM Specification GM 3651G

Removal Procedure

Warning

If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Note:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. When replacing or removing the left side stationary window. Refer to Body Side Trim Panel Replacement - Left Side Body Side Trim Panel Replacement - Left Side.

2. When replacing or removing the right side stationary window. Refer to Body Side Trim Panel Replacement - Right Side Body Side Trim Panel Replacement - Right Side.

Warning

If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

3. Cover to protect the following parts from broken glass:

* The upper dash pad

* The defroster outlets and A/C outlets

* The seats

* The carpeting





Warning

When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

4. Cover to protect the following parts from broken glass:

1. Upper dash pad

2. Defroster outlets and A/C outlets

3. Seats and carpeting





Note:
Keep the cutting edge of the tool against the window.

5. This will allow the urethane adhesive to be separated from the window.

* Leave a base of urethane on the pinchweld flange.

* The only suitable lubrication is clear water.

* Use J 24402-A - glass sealant remover (cold knife), J 39032 - stationary glass removal tool or equivalent in order to remove the window.





6. Remove the stationary window from the pinchweld flange with the aid of an assistant.

Installation Procedure

1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows Adhesive Installation of Stationary Windows.

2. When replacing or installing the left side stationary window. Refer to Body Side Trim Panel Replacement - Left Side Body Side Trim Panel Replacement - Left Side.

3. When replacing or installing the right side stationary window. Refer to Body Side Trim Panel Replacement - Right Side Body Side Trim Panel Replacement - Right Side.

4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.