Glow Plug Control Module Replacement

Glow Plug Control Module Replacement

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Service and Repair.

2. Remove the engine cover. Refer to Engine Cover Replacement Service and Repair.

3. Disconnect the engine wiring harness electrical connector (1) from the glow plug control module.




4. Disconnect the positive battery cable (1) from the glow plug control module.




5. Remove the glow plug control module bolts (1).

6. Remove the glow plug control module (2).

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Position the glow plug control module (2).

2. Install the glow plug control module bolts (1) and tighten to 10 Nm (89 lb in).




3. Connect the positive battery cable (1) to the glow plug control module.




4. Connect the engine wiring harness electrical connector (1) to the glow plug control module.

5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Service and Repair.

6. If a NEW glow plug control module was installed, program the module. Refer to Control Module References Control Module References.

7. Install the engine cover. Refer to Engine Cover Replacement Service and Repair.