Engine Control Module Programming and Setup (Gasoline Engines)

Engine Control Module Programming and Setup (Gasoline Engines)

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

* The ECM Reprogramming-Refer to Service Programming System (SPS) Service Programming System (SPS).

* The CKP Variation Learn-Refer to Crankshaft Position System Variation Learn for V8 engines or Crankshaft Position System Variation Learn for V6.

* The Throttle Learn procedure-Refer to Throttle/Idle Learn or Throttle/Idle Learn for V8.

* The Theft Deterrent Programming-Refer to Theft Deterrent Module Programming and Setup Testing and Inspection.

* Brake Pedal Position Sensor Learn-Refer to Brake Pedal Position Sensor Learn Programming and Relearning.

* The Fuel Composition Diagnostic-Refer to Fuel Composition Diagnosis for the Flex Fuel engines.

* Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.

* Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.

ECM Reprogramming

Note: DO NOT reprogram a FlexFuel (E85) vehicle while the fuel composition learn function is active. If necessary, drive the vehicle until the scan tool indicates that the fuel composition learn parameter is inactive. Programming with the fuel composition learn active will result in fuel trim DTCs.

* If the ECM needs to be reprogrammed, refer to Service Programming System (SPS) Service Programming System (SPS).

* Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.

* Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a CKP Variation Learn Procedure must be performed. Refer to Crankshaft Position System Variation Learn for V8 engines or Crankshaft Position System Variation Learn for V6.

* Engine replacement

* Any engine repair that disturbs the crankshaft position (CKP) sensor or its relationship with the crankshaft reluctor wheel

* CKP sensor

If the throttle body is replaced or a throttle body cleaning procedure is completed, the Throttle/Idle Learn procedure must be performed. Refer to Throttle/Idle Learn for V8 or Throttle/Idle Learn for V6.