Balancer Shaft Bearing Installation

Balancer Shaft Bearing Installation

Special Tools

J 38834 - Balance Shaft Service Kit

For equivalent regional tools, refer to Special Tools Special Tools.





Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


1. Use the J 38834 - kit in order to install the balance shaft rear bearing.

1. Install the J 38834-3 onto the short threaded end of the J 38834-1.

2. Install the J 38834 - kit nut, the washer, and the bearing on the long threaded end of the J 38834-1.

3. Install the J 38834-2 onto the J 38834-1 so that the smaller diameter of the J 38834-2 will be facing the front of the engine block.

4. Install the J 38834-2 on the inside of the balance shaft front bearing bore.

5. Lubricate the NEW balance shaft rear bearing with clean engine oil.

6. Install the balance shaft rear bearing onto the J 38834-2.

7. Align the balance shaft rear bearing for installation.

8. Using a wrench secure the J 38834-1 into place.

9. Rotate the J 38834 - kit nut until the balance shaft rear bearing is properly and completely pushed into the balance shaft rear bearing bore.

2. Remove the J 38834 - kit.