Fuel Pump Flow Control Module Replacement

Fuel Pump Flow Control Module Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the electronic brake control module (EBCM) shield retainers (2).

3. Remove the EBCM shield bolts (3) and shield (1).





4. Disconnect the chassis wiring harness electrical connector (1) from the fuel pump flow control module.





5. Loosen the fuel pump flow control module bolts (1).

6. Slide the fuel pump flow control module (2) towards the passenger side of the vehicle.

7. Remove the fuel pump flow control module from the vehicle.

Installation Procedure





1. Position the fuel pump flow control module (2) to the vehicle.

2. Slide the fuel pump flow control module towards the driver side of the vehicle.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Tighten the fuel pump flow control module bolts (1).

Tighten the bolts to 9 Nm (80 lb in).





4. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module.





5. Position the EBCM shield (1) to the underbody and install the EBCM shield bolts (3).

Tighten the bolts to 20 Nm (15 lb ft).

6. Install the EBCM shield retainers (2).

7. Lower the vehicle.

8. Program the fuel pump flow control module. Refer to Control Module References Control Module References.