Oil Pump Locating Pin Replacement

Oil Pump Locating Pin Replacement

Special Tools

J 43779 - Locating Pin Installer

For equivalent regional tools, refer to Special Tools Tools and Equipment.





Note:
Do not replace the oil pump locating pin or pins unless the pin or pins are damaged.

1. Remove the locating pin (2) from the oil pump body (3).

Caution:
DO NOT mar the oil pump body surface when installing the locating pin(s). Tap gently on the locating pin installer tool. Heavy or continued hammering will damage the oil pump body surface.

2. Using J 43779 - installer (1), install the locating pin (2) to the specified height.

The locating pin installed height measurement is 10.7-11.3 mm (0.42-0.44 in) above the oil pump body surface.