Operation CHARM: Car repair manuals for everyone.

1-2-3-4 Clutch Backing Plate Inspection




1-2-3-4 Clutch Backing Plate Inspection





Important:
Measure as described below at a minimum of 3 locations. Replace the 1-2-3-4 clutch backing plate if the specifications are not met.


1. Measure the wear surface thickness of the 1-2-3-4 clutch backing plate (1) at dimension A for minimum thickness.

2. Refer to the 1-2-3-4 clutch backing plate table in Selective Components Specifications Selective Components Specifications for the correct size backing plate.





Important:
Check the backing plate for coning on a level surface.


3. Measure the cone of the 1-2-3-4 clutch backing plate (1) at dimension A.

4. Replace the backing plate (1) if any cone is measured.