OnStar Voice Recognition Malfunction

OnStar Voice Recognition Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The telematics communication interface control module is capable of interpreting voice commands received over the cellular microphone circuit. Speech recognition allows the user to speak to one computer in the vehicle, and one reached over the cellular communication network. The module attempts to understand the users command, and responds by speaking back, or by taking the appropriate action, e.g. dialing the phone.

Reference Information

Schematic Reference

OnStar Schematics OnStar Schematics

Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)

Description and Operation

OnStar Description and Operation OnStar

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Circuit/System Verification

Note:

* It is necessary to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites.

* The vehicle should be located in a quiet area.

1. Ignition ON, press the blue OnStar Call button.

2. Verify that your voice is heard clearly by the OnStar Call center.

• If your voice can not be heard clearly
Refer to OnStar Microphone Malfunction OnStar Microphone Malfunction

• If your voice can be heard clearly

3. Verify that the system responds appropriately to all voice commands by pressing the blue OnStar Call button and attempting to operate the system using multiple voice commands.

• If the OnStar system does not respond to any voice commands
Test or replace the K73 telematics communication interface control module

• If the OnStar system responds to some, but not all voice commands
Refer to OnStar Description and Operation OnStar for tips on proper pronunciation

• If the OnStar system responds to all voice commands

4. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Control Module References Control Module References for telematics communication interface control module replacement, programming and setup.