Fuel Rail and Injectors Removal

Fuel Rail and Injectors Removal

Special Tools

EN-49248 - Fuel Rail Assembly Remover

For equivalent regional tools, refer to Special Tools Special Tools





1. Remove the fuel injection fuel rail noise shield (1).





2. Disconnect the electrical harness from the fuel rail harness connection.

3. Disconnect all 4 fuel injector electrical connections.

4. Remove the fuel rail assembly retaining bolts.

Note:
Use care to avoid contact with the fuel rail harness during special tool installation and fuel rail removal.

5. Install EN-49248 - studs (1) into the 2 center fuel rail assembly retaining bolt locations. Tighten the studs to 22 Nm (16 lb ft).

6. Install EN-49248 - remover (2) onto each stud, and engage the hooks to the fuel rail. Install the nuts (3) retaining the remover onto the studs and tighten until snug.





Note:
EN-49248 will assist in the proper removal of the fuel rail assembly. Ensure that the following conditions are met:

* Turn the handles simultaneously in order to pull the fuel rail straight out along the fuel injector axis.

* DO NOT twist when pulling out on the fuel rail and injector assembly.

7. Using EN-49248 - remover, remove the fuel rail assembly (1).