Turn Signal Switch Cancel Cam Position Plate Replacement

Turn Signal Switch Cancel Cam Position Plate Replacement

Tools Required

* J 23653-SIR - Steering Column Lock Plate Compressor

* J 42137 - Cam Orientation Plate Adapter

Removal Procedure

1. Remove the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Steering Wheel Airbag Coil Replacement Removal and Replacement.





Important: DISCARD the old steering shaft lock plate ring.


2. Remove the following parts from the steering shaft:

1. Steering shaft lock plate retaining ring (1) using J 23653-SIR - steering column lock plate compressor and J 42137 - cam orientation plate adapter.

2. Turn signal switch cancel cam position plate (2)

3. Turn signal switch cancel cam (3)

Installation Procedure





Important: Use a NEW steering shaft lock plate retaining ring.


1. Install the following parts onto the steering shaft:

1. Lubricate the turn signal switch cancel cam (3) with GM P/N 12377900 (Canadian P/N 10953529).

2. Turn signal switch cancel cam position plate (2)

3. Steering shaft lock plate retaining ring (1) using J 23653-SIR - steering column lock plate compressor and J 42137 - cam orientation plate adapter.

2. Install the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Steering Wheel Airbag Coil Replacement Removal and Replacement.