Evaporative Emission Canister Replacement

Evaporative Emission Canister Replacement

Removal Procedure

Note:
Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Disconnect the fuel tank EVAP line quick connect fitting (3) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.

3. Disconnect the fuel tank EVAP line quick connect fitting (2) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.

4. Disconnect the EVAP pipe quick connecting fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.





5. Remove the EVAP canister bracket bolts (1).

6. Remove the EVAP canister assembly (2) from the tab on the frame bracket.





7. Remove the EVAP canister bolt (1).

8. Remove the EVAP canister (2) from the bracket (3).

Installation Procedure





1. Install the EVAP canister (2) to the bracket (3).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the EVAP canister bolt (1).

Tighten the bolt to 25 Nm (18 lb ft).





3. Position and install the EVAP canister assembly (2) to the fame bracket tab.

4. Install the EVAP canister bolts (1).

Tighten the bolts to 25 Nm (18 lb ft).





5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.

6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.

7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.

8. Lower the vehicle.