Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENT

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Vacuum hose from Manifold Absolute Pressure (MAP) sensor.
3. MAP sensor electrical connector.
4. One bolt and MAP sensor and bracket from bulkhead.

INSTALL OR CONNECT
1. MAP sensor to bracket and bulkhead; secure with one bolt. Tighten MAP sensor bracket bolt to 10 Nm (89 lb. in.).
2. MAP sensor electrical connector.
3. Vacuum hose to MAP sensor.
4. Negative (-) battery cable. Tighten Negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).