Brakes - New Procedure To Replace ABS Reluctor Ring

File In Section: 5 Brakes

Bulletin No.: 73-50-20

Date: May, 1997

Subject:
Section 5E-1 - Antilock Brake System - New Procedure to Replace Reluctor Ring

Models:
1996-97 Geo Tracker

This bulletin is being issued to add the reluctor ring replacement procedure to Section 5E-1 of the Service Manual.

Front Wheel Speed Sensor Reluctor Ring Remove





Figure 1

1. Remove the wheel hub with reluctor ring. Refer to Wheel Hub and Bearing replacement in Front Suspension Section of the Service Manual.

2. Remove the reluctor ring from the wheel hub.

Notice:
Remove the reluctor ring from the wheel hub gradually and evenly. Attempting to remove the reluctor ring unevenly may damage the part.

Install





Figure 2

1. Install the reluctor ring onto the wheel hub.

2. Use a pipe to press the reluctor ring onto the wheel hub evenly.

Important:
Contact surface of the pipe should be clean and flat. The pipe should have an inside diameter of 98 - 104 mm (3.86 - 4.09 in). The pipe should not contact the teeth of the reluctor ring.

3. Install the wheel hub with reluctor ring. Refer to Wheel Hub and Bearing replacement in Front Suspension Section of the Service Manual.