Case Disassembly and Major Shafts

REMOVE OR DISCONNECT

^ Tool Required:
- J 37637 Case Separator





1. Clutch release bearing from input shaft.
2. Eight clutch housing bolts and clutch housing from upper and lower case.
3. Four bolts and gearshift lever case from rear case.





4. Twelve bolts and rear case from upper and lower case.





5. Eight bolts from input shaft bearing retainer. Using two flat-bladed tools, remove input shaft bearing retainer from upper and lower cases.





6. Ten upper-to-lower case retaining bolts and separate upper and lower case halves using J 37637.
7. Main shaft and input shaft assembly from lower case.
8. Input shaft and input shaft needle bearing from main shaft.

Important
- The input shaft rides on a reeve bearing between the input shaft and main shaft assembly. When separating the input shaft from the main shaft assembly, the needle bearing may remain either in the input shaft or on the main shaft assembly. Remove the input shaft needle bearing to prevent damage when servicing the input shaft and main shaft assembly.