Headlamp Relay: Service and Repair

Turn/Hazard Relay, Horn Relay, Or Headlamp Relays 1 And 2 Location:

The location of the headlamp relays 1 and 2 depends on the date of vehicle production:
^ On vehicles produced before December 4, 1995, the headlamp relays 1 and 2 are mounted on a bracket which is bolted onto the right-hand side of the heater case.
^ On vehicles produced on and after December 4, 1995, the headlamp relays 1 and 2 are mounted on a bracket which is bolted onto the blower case.

Vehicles Produced Prior to December 4, 1995

Remove or Disconnect
1. Negative (-) battery cable.
2. Pull out instrument panel compartment while pushing its stopper from both left and right sides.
3. Two screws and relay mounting bracket from heater case.

IMPORTANT
^ Refer to Power and Ground Distribution for proper identification of the headlamp relays 1 and 2.

4. Headlamp relay(s) from mounting bracket by releasing locking tab(s).
5. Headlamp relay(s) electrical connector(s) and remove headlamp relay(s) from vehicle.

Install or Connect
1. Headlamp relay(s) electrical connector(s).
2. Headlamp relay(s) to mounting bracket.
3. Relay mounting bracket to heater case; secure with two screws.
4. Close instrument panel compartment.
5. Negative (-) battery cable.

Vehicles Produced on and after December 4, 1995

Remove or Disconnect
1. Negative (-) battery cable.
2. Two screws securing headlamp relays 1 and 2 mounting bracket to the blower case.

IMPORTANT
^ Refer to Power and Ground Distribution for proper identification of the headlamp relays 1 and 2.

3. Headlamp relay(s) electrical connectors.
4. Slide headlamp relay(s) off mounting bracket.

Install or Connect
1. Slide the headlamp relay(s) onto mounting bracket.
2. Headlamp relay(s) electrical connectors.
3. Headlamp relays 1 and 2 mounting bracket to blower case; secure with two screws.
4. Negative (-) battery cable.