SIR Coil and Combination Switch (& Hazard Warning Switch)

NOTE: In the event deployment has occurred, inspect the Supplemental Inflatable Restraint (SIR) coil assembly wire for any signs of scorching, melting or other damage due to excessive heat. If the coil assembly is damaged, replace it.

REMOVE OR DISCONNECT

CAUTION: Place the ignition switch in the "LOCK" position to prevent the SIR coil assembly from becoming uncentered.

1. Disable the SIR.
2. Negative (-) battery cable.
3. Steering wheel from steering column.





4. Four screws and knee bolster trim cover.
5. Two bolts and knee bolster from steering column.





6. Five screws from steering column lower cover and remove upper and lower covers.
7. SIR coil and combination switch electrical connectors.
8. Retaining bands securing SIR coil and combination switch wiring harness to steering column.





9. Three retaining screws and SIR coil and combination switch from steering column.

INSTALL OR CONNECT
1. SIR coil and combination switch to steering column; secure with three screws.
2. SIR coil and combination switch electrical connectors.
3. Secure SIR coil and combination switch wiring harness to steering column with retaining bands.
4. Upper and lower steering column covers to column; secure with five screws.
5. Knee bolster to steering column; secure with two bolts.
6. Lower steering column trim panel; secure with four screws.
7. Steering wheel to steering column.
8. Negative (-) battery cable.
9. Enable the SIR.