Shift Select Cable

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Place manual selector in "N" (neutral) position.
3. Console box from floor.





4. Shift lock solenoid electrical connector under carpet.
5. Shift indicator lamp electrical connector under carpet.





6. Four bolts and manual selector from floor.





7. Retaining clip, washer, E-clip and shift select cable from selector lever.
8. Raise and suitably support vehicle.





9. Select cable locknut and shift select cable from manual shift lever.
10. E-clip from shift select cable bracket on transmission and shift select cable from vehicle.

Inspect
- Shift select cable for fraying or kinks. Replace as necessary.

INSTALL OR CONNECT





1. Place manual shift lever in "L" (low) position.
2. Shift select cable into shift select cable bracket at transmission; secure with E-clip.





3. Shift select cable into manual shift lever while moving manual shift lever back to the "N" (neutral) position; secure with select cable locknut. Do not tighten fully.
4. Lower vehicle to where access is possible to both the manual selector and the manual shift lever.
5. Shift select cable to selector lever; secure faith E-clip, washer and retaining clip.

Inspect
- Both ends of the shift select cable making sure no cable deflection exists.

- Tighten shift select cable locknut to 7 Nm (69 inch lbs.).

6. Completely lower vehicle.
7. Manual selector to floor: secure with four bolts.
- Tighten manual selector bolts to 18 Nm (13 ft. lbs.).
8. Shift indicator lamp electrical connector under carpet.
9. Shift lock solenoid electrical connector under carpet.
10. Console box to floor.
11. Place manual selector in "P" (park) position.
12. Negative (-) battery cable.