Remove or Disconnect

Passenger Side SIR Assembly:

Parking Brake Level Bezel:

Console:

Center Trim Bezel:

Radio Removal:

Knee Bolster:

Heater Control Unit Control Cables:

Instrument Panel Left Side Support Screw:

Instrument Panel Fastener Location (right Side Shown, Left Similar):

Instrument Panel Compartment Lower Support Screws:

Instrument Panel Upper Bolts:

1. Negative (-) battery cable.
2. Disable the SIR. Refer to Disabling the Supplemental Inflatable Restraint (SIR) System.
3. Pull out instrument panel compartment while pushing its stopper from both left and right sides.
4. Two plastic hinge pins and instrument panel compartment.
5. Two screws and set aside hood release handle.
6. Two screws, three bolts and passenger-side SIR module.
7. Two plastic retaining clips, two screws, two electrical connectors (if equipped with power windows) and parking brake lever bezel from vehicle.
8. Two screws, two plastic retaining clips and lift console.
9. Power/Normal switch electrical connector (if equipped with 4-speed A/T) and remove console from vehicle.
10. Ashtray from guide by depressing spring-loaded tab and pulling ashtray out from the guide.
11. Four knobs from heater control unit.
12. Heater control unit face plate from center trim bezel by pulling straight out.
13. Illumination lamp bulb socket from heater control unit.
14. Four screws and center trim bezel.
15. A/C switch electrical connector (if equipped).
16. Four screws, two electrical connectors and radio.
17. Four screws and knee bolster trim panel.
18. Pull gently top portion of knee bolster trim panel to release two retainers.
19. Two bolts and knee bolster from instrument panel.
20. Steering column.
21. Four screws and instrument cluster bezel.
22. Four screws and instrument cluster assembly.
23. Three electrical connectors and speedometer cable from instrument cluster assembly.
24. Mode and temperature control cables on right side of heater case.
25. Fresh/Recirculation control cable at blower case.
26. Blower switch electrical connector and heater control unit from vehicle.
27. Instrument panel harness electrical connectors.
28. One screw holding left side of the instrument panel support beam to vehicle.
29. One screw on bottom left side of instrument panel.
30. Left side instrument panel support beam cover and two bolts.
31. Right side instrument panel support beam cover and two bolts.
32. Left and right screws at bottom of instrument panel compartment support.
33. Two front speaker grills and instrument panel upper center cover with flat-bladed screwdriver.
34. Three screws along top of instrument panel.
35. Pull instrument panel from support member.
36. Instrument panel from vehicle.