Front

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Wheel speed sensor jumper to harness connector (located behind Headlamp assembly inside the engine compartment).
3. Raise and suitably support vehicle.
4. Wheel speed sensor electrical connector.
5. Two bolts and jumper harness from vehicle.

INSTALL OR CONNECT
1. Jumper harness to vehicle, then tighten to 8 Nm (70.8 inch lbs.).
2. Wheel speed sensor electrical connector.
3. Lower vehicle.
4. Wheel speed sensor jumper to harness connector.
5. Negative (-) battery cable.