Four-Wheel Drive Switch (If Equipped)
REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Two screws, two plastic retainers and rear console box from floor.
3. Two screws, two plastic retainers and front console box from floor.
4. One screw and gearshift control lever knob from gearshift control lever.
5. Eight screws, boot cover and gearshift control lever boot from gearshift control lever.
6. One clamp and gearshift lever case boot from gear shift lever case.
7. Gear shut control lever from gearshift lever case by pushing down on the gearshift control lever pivot and turning counterclockwise 90° (1/4 turn) and lifting up.
8. Four-wheel drive switch electrical connector from four-wheel drive switch.
9. Four-wheel drive switch from transfer case by turning counterclockwise.
- Four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.
INSTALL OR CONNECT
1. Four-wheel drive switch into transfer case by turning clockwise.
- Four-wheel drive switch to 20 Nm (15 ft. lbs.).
2. Four-wheel drive switch electrical connector to four-wheel drive switch.
3. Gearshift control lever into gearshift lever case and pushing down on the shift control lever pivot and turning clockwise 90° (1/4 turn) and releasing.
4. Gearshift lever case boot to gearshift lever case; secure with one clamp.
5. Gearshift control lever boot and boot cover onto gearshift control lever; secure with eight screws.
6. Gearshift control lever knob onto gearshift control lever; secure with one screw.
7. Front console box to floor; secure with two plastic retainers and two screws.
8. Rear console box to floor; secure with two plastic retainers and two screws.
9. Negative (-) battery cable.