Input Shaft

REMOVE OR DISCONNECT

^ Tools Required:
- J 34757 Circlip Remover
- J 22912-01 Split Plate
- J 26941 Transmission Case Bearing Cup Remover
- J 23907 Slide Hammer

1. Input shaft needle bearing from input shaft.
2. Front input shaft bearing C-clip from the input shaft using J 34757.





3. Front input shaft bearing from input shaft using J 22912-01 and press arbor.





4. Front input shaft oil seal from the input shaft bearing retainer using J 26941 with J 23907.

CLEAN
1. Input shaft components with solvent and air dry.
2. Input shaft bearing retainer mating surface.

INSPECT
- Input shaft for scoring or excessive wear. Replace as necessary.
- Input shaft bearing for roughness or wear. Replace as necessary.
- Input shaft needle bearing for roughness or damage. Replace as necessary.

INSTALL OR CONNECT

^ Tools Required:
- J 37209 Stub Shaft Seal Installer
- J 37753 Bearing Installer
- J 35664 Bearing Installer
- J 36850 Transjel(tm) Transmission Assembly Lubricant

1. Apply J 36850 to the input shaft bearing retainer
seal surface.





2. New front input shaft oil seal into the input shaft bearing retainer using J 37209 and hammer.





3. Front input shaft bearing onto input shaft using J 37753 with J 35664 and press arbor.
4. Front input shaft bearing C-clip onto input shaft.
5. Apply J 36850 to the input shaft needle bearing.





6. Input shaft needle bearing into input shaft.