Cowl Moulding / Trim: Service and Repair
Cowl Cover Replacement1. Remove the windshield wiper arms.
2. Using a clip remover, detach the clips (A), then remove the front seal (B) and hood rear seal rubber (C). Take care not to scratch the cowl covers.
3. Detach the clips (D), and release the hooks (E, F) by carefully pulling the passenger's cowl cover (G) upward. Pull the hinge cover (H) out from the front fender (I), and release the windshield washer tube (J), then remove the cover. Take care not to scratch the body.
4. Detach the clips (0), and release the hooks (K) by carefully pulling the driver's cowl cover (L) upward. Pull the hinge cover (M) out from the front fender (N), then remove the cover. Take care not to scratch the body.
5. Install the covers in the reverse order of removal, and note these items:
- Replace any damaged clips.
- Push the clips into place securely.