Relay Box: Service and Repair

Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS section before performing repairs or service.

Removal

1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
3. Driver's fuse box: Remove the left kick panel and dashboard lower cover. Passenger's fuse box: Remove the right kick panel and glove box.




4. Remove the mounting nut or bolt, and pull the driver's under-dash fuse/relay box (A) or passenger's under-dash fuse/relay box (B) away from the body.
5. Disconnect the driver's or passenger's under-dash fuse/relay box connectors, and remove the driver's or passenger's under-dash fuse/relay box.

NOTE: The dashboard wire harness A (driver's under-dash fuse/relay box connector B) 2P connector for SRS is a spring-loaded lock type.

Installation

1. Connect the connectors to the driver's or passenger's under-dash fuse/relay box, then install the driver's or passenger's under-dash fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Connect both the negative cable and positive cable to the battery, enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets, and set the clock.
4. Do the PCM idle learn procedure.
5. Do the power window control unit reset procedure.
6. Confirm that all systems work properly.