Fuel Pump: Service and Repair

Fuel Pump Replacement

Special Tools Required
Fuel sender wrench 07AAA-001A100

1. Turn the ignition switch OFF.
2. Remove the driver's side second row seat.





3. Cut the carpet at the dotted line (A). Be careful not to cut the wire harness under the carpet.





4. Remove the access panel (A) from the floor, then disconnect the fuel pump 5P connector (B).
5. Remove the fuel fill cap.
6. Relieve fuel pressure.
7. Disconnect the quick-connect fittings from the fuel tank unit.





8. Using the tool, loosen the fuel tank unit locknut (A).





9. Remove the fuel tank unit (A).





10. Remove the bracket (A), the fuel filter (B), the fuel gauge sending unit (C), the housing (D), and the wire harness (E).
11. When connecting the fuel pump, make sure the connection is secure and the suction filter (F) is firmly connected to the fuel pump (G).
12. Check these items before installing the fuel tank unit;
- When connecting the wire harness, make sure the connection is secure and the connector (H) is firmly locked into the place.
- Do not push the lower part of the suction filter.
- When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.

13. Install the parts in the reverse order of removal with a new base gasket. When installing the fuel tank unit, align the marks (J) on the unit (K) and the fuel tank (L).