SRS Unit Replacement

SRS Unit Replacement

Removal

1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's and front passenger's airbag connectors.
3. Disconnect the side airbag connectors.
4. Disconnect both seat belt tensioner connectors.
5. Remove the center lower cover.




6. Pull down the console carpet on the passenger's side, then remove the Torx bolt (A) from the SRS unit.




7. Pull down the console carpet on the driver's side, then disconnect the connectors. Remove the Torx bolts (A), then pull out the SRS unit.

Installation




1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors to the SRS unit, and push them into place until they click.

NOTE: When tightening the Torx bolts to the specified torque, be careful to turn them in so that their heads rest squarely on the brackets.

2. Reinstall the center lower cover.
3. Reconnect the driver's and front passenger's airbag connectors.
4. Reconnect the side airbag connectors.
5. Reconnect both seat belt tensioner connectors.
6. Reconnect the battery negative cable.
7. Initialize the OPDS unit.

NOTE: Initialization is only needed if you installed a new SRS unit.

8. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.