Console Accessory Power Socket B
Console Accessory Power Socket B Test/Replacement1. Remove the console rear trim.
2. Disconnect the 2P connector from the console accessory power socket.
3. Inspect the connector terminals to be sure they are all making good contact.
- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the socket.
- If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the No. 2 terminal and body ground. There should be battery voltage.
- If there is battery voltage, go to step 5.
- If there is no battery voltage, check for:
- Blown No. 8 (7.5 A) fuse in the driver's under-dash fuse/relay box.
- Blown No. 61 (20 A) fuse in the auxiliary fuse box.
- Faulty rear accessory power socket relay.
- Poor ground (G401, G501).
- An open in the wire.
5. Check for continuity between the No. 1 terminal and body ground. There should be continuity.
- If there is continuity, go to step 6.
- If there is no continuity, check for:
- Poor ground (G501).
- An open in the wire.
6. Remove the housing (A) and socket (B).
7. Install the power socket in the reverse order of removal.