P0108
DTC P0108: MAP Sensor Circuit High Voltage1. Turn the ignition switch ON (II).
2. Check the MAP SENSOR in the DATA LIST with the HDS.
Is about 160 kPa (47.1 in.Hg, 1,197 mmHg), 4.49 V or more indicated?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the MAP sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the MAP sensor 3P connector.
5. Connect MAP sensor 3P connector terminals No.2 and No.3 with a jumper wire.
6. Turn the ignition switch ON (II).
7. Check the MAP SENSOR in the DATA LIST with the HDS.
Is about 160 kPa (47.1 in.Hg, 1,197 mmHg), 4.49 V or more indicated?
YES - Go to step 8.
NO - Go to step 18.
8. Remove the jumper wire from MAP sensor 3P connector.
9. Measure voltage between MAP sensor 3P connector terminals No.1 and No.3.
Is there about 5 V?
YES - Go to step 14.
NO - Go to step 10.
10. Turn the ignition switch OFF.
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector B (44P).
13. Check for continuity between PCM connector terminal B33 and MAP sensor 3P connector terminal No.3.
Is there continuity?
YES - Go to step 25.
NO - Repair open in the wire between the PCM (B33) and MAP sensor then go to step 20.
14. Turn the ignition switch OFF.
15. Jump the SCS line with the HDS.
16. Disconnect PCM connector B (44P).
17. Check for continuity between PCM connector terminal B30 and MAP sensor 3P connector terminal No.2.
Is there continuity?
YES - Go to step 25.
NO - Repair open in the wire between the PCM (B30) and the MAP sensor, then go to step 20.
18. Turn the ignition switch OFF.
19. Replace the MAP sensor.
20. Reconnect all connectors.
21. Turn the ignition switch ON (II).
22. Reset the PCM with the HDS.
23. Do the PCM idle learn procedure.
24. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0108 is indicated, check for poor connections or loose terminals at MAP sensor and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - Troubleshooting is complete.
25. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
26. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0108 is indicated, check for poor connections or loose terminals at MAP sensor and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM.