Operation CHARM: Car repair manuals for everyone.

OBD Status

OBD Status
The OBD status shows the current system status of each DTC and all of the parameters. This function is used to see if the technician's repair was successfully finished. The results of diagnostic tests for the DTC are displayed as:
^ PASSED: On board diagnosis is successfully finished.
^ FAILED: On board diagnosis has finished but failed.
^ NOT COMPLETED: The on board diagnosis was running but is out of the enable conditions of the DTC.

DTC CLEAR
1. Clear the DTC with the HDS while the engine is stopped.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON (II), and wait for 30 seconds.
4. Turn the ignition switch OFF, and disconnect the HDS from the DLC.

PCM RESET
This command clears stored specific data from each vehicle such as DTCs, freeze data, and readiness codes. It does not clear CKP PATTERN data.
1. Reset the PCM with the HDS while the engine is stopped.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON (II), and wait for 30 seconds.
4. Turn the ignition switch OFF, and disconnect the FIDS from the DLC.
5. Do the PCM idle learn procedure.