Operation CHARM: Car repair manuals for everyone.

Disconnecting System Connectors

Disconnecting System Connectors

Turn the ignition switch OFF, disconnect the negative cable from the battery, and wait at least 3 minutes before beginning the following procedures.




- Before disconnecting the cable reel 4P connector (2), disconnect the driver's airbag 4P connector (3).
- Before disconnecting SRS unit connector B (5) from SRS unit, disconnect both seat belt tensioner 4P connectors (8, 9).

1. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait at least 3 minutes.

Driver's Airbag




2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.

Front Passenger's Airbag




3. Remove the glove box, then disconnect the front passenger's airbag 4P connector (A) from dashboard wire harness A.

Side Airbag




4. Disconnect both side airbag 2P connectors (A) from the SRS floor harness.

Seat Belt Tensioner




5. Remove the B-pillar lower trim panel. Disconnect the seat belt tensioner 2P connector (A) from the SRS floor harness 2P connector (B).

SRS Unit




6. Remove the center console side trim. Disconnect SRS unit connector A, SRS unit connector B from the SRS unit.