Park Pin Switch Test

Park Pin Switch Test
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS before performing repairs or service.
1. Remove the steering column covers.
2. Disconnect the park pin switch connector.





3. Shift the shift lever into the P position, then check for continuity between the No. 1 and No. 3 terminals. There should be no continuity.
4. Move the shift lever out of the P position, and check for continuity the terminals. There should be continuity.
5. If the park pin switch is faulty, replace the shift lever assembly. The park pin switch is not available separately.