Window Glass: Adjustments
Front and Rear Door Glass AdjustmentNOTE:
- Check the weatherstrips and glass run channel for damage or deterioration, and replace them if necessary.
- Wipe the run channel clean with a shop towel.
- Lubricate the run channel with Shin-Etsu grease P/N 08798-9013.
1. Place the vehicle on a firm, level surface.
2. Remove these items:
- Front door panel, rear door panel
- Front door plastic cover, rear door plastic cover
- Front door power window control unit, driver's side
3. Carefully move the glass (A) until you can see the glass mounting bolts (B), then loosen them.
4. Push the glass against the center channel (C), then tighten the glass mounting bolts.
5. Check that the glass moves smoothly.
6. Raise the glass fully, and check for gaps. Check that the glass (A) contacts the glass run channel (B) evenly.
7. Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:
- Use a 12 mm (1/2 in) diameter hose (A).
- Adjust the rate of water flow as shown (B).
- Do not use a nozzle.
- Hold the hose about 300 mm (12 in) away from the door.
8. Attach the plastic cover, and reinstall the door panel, front door, rear door.
9. Test-drive and check for wind noise.