Distributor: Service and Repair

W/FUEL INJECTED ENGINE
1. Disconnect ground wire from radio noise condenser.
2. Tag spark plug wires for proper installation, then disconnect them and the coil wire from the distributor.
3. Disconnect 4 pin connector from distributor.
4. Remove distributor hold down bolts and the distributor.
5. Coat new O-ring with engine oil and install it on distributor, then place distributor in position.
6. Install hold down bolts and tighten temporarily.
7. Connect 4 pin connector to distributor and the ground wire to radio noise condenser.
8. Connect coil and spark plug wires at distributor.
9. Adjust ignition timing, then tighten hold down bolts.