Hood Seal and Hood Molding

Hood Seal Rubber and Hood Molding Replacement







1. Using a clip remover, detach the clips, then remove the hood seals (A). On Canadian models, remove the hood molding (B). On Canadian Coupe model, Carefully peel the hood molding adhesive tapes (F) off of the hood. Take care not to scratch the hood.
2. Install the hood seal and hood molding in the reverse order of removal, and note these items:
- Replace any damaged clips.
- On Canadian Coupe model: If the old hood molding is to be reinstalled, scrape off all traces of the old adhesive tape, then clean the molding surface with alcohol. Apply primer (3M K500, or equivalent) to the hood molding where the new adhesive tape will attach, then give the molding into place securely with new adhesive tape.