Balance Shaft Seal: Service and Repair
Balancer Shaft Seals Installation -In-carSpecial Tools Required
^ Hub Assembly Guide Attachment 07GAF-SE00200
^ Attachment, 30 mm I.D. 07746-0030300
1. Dry the crankshaft oil seal housing.
2. Apply a light coat of grease to the balancer shaft and to the lip of the seal.
3. Using the special tools, drive in the front balancer shaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess grease off the balancer shaft, and check that the oil seal lip is not distorted.