P0720
DTC P0720: Problem in Countershaft Speed Sensor CircuitNOTE: Record all freeze data before you troubleshoot.
1. Check the countershaft speed sensor installation.
Is the countershaft speed sensor installed properly?
YES - Go to step 2.
NO - Reinstall and rechecks
2. Disconnect the countershaft speed sensor 2P connector.
3. Measure countershaft speed sensor resistance at the sensor connector.
Is the resistance 400 - 600 ohms?
YES - Go to step 4.
NO - Replace the countershaft speed sensor.
4. Disconnect PCM connector D (16P).
5. Check for continuity between body ground and the D10 terminal and D16 terminal individually.
Is there continuity?
YES - Repair short to ground in the wires between the D10 and D16 terminals and the countershaft speed sensor.
NO - Go to step 6.
6. Connect the countershaft speed sensor connector.
7. Measure the resistance between the D10 and D16 terminals.
Is the resistance 400 - 600 ohms?
YES - Check for loose terminal fit in the PCM connectors. If necessary, substitute a known-good PCM and rechecked.
NO - Repair loose terminal or open in the wires between the D10 and D16 terminals and the countershaft speed sensor.