Operation CHARM: Car repair manuals for everyone.

P1298

DTC P1298: ELD Circuit High Voltage

1. Reset the ECM/PCM.
2. Start the engine.
3. Turn on the headlights.

Is DTC P1298 indicated?

YES - Go to step 4.

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at C204 (located under the right side of dash), the ELD, and the ECM/PCM.

4. Turn the ignition switch and headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).




7. Measure voltage between body ground and ELD 3P connector terminal No.1.

Is there battery voltage?

YES - Go to step 8.

NO - Repair open in the wire between the No.6 ECU (PCM) CRUISE CONTROL (15 A) fuse and the ELD.

8. Turn the ignition switch OFF.




9. Connect ELD 3P connector terminal No.3 to body ground with a jumper wire.
10. Disconnect ECM/PCM connector A (32P).




11. Check for continuity between ECM/PCM connector terminal A30 and body ground.

Is there continuity?

YES - Go to step 12.

NO - Repair open in the wire between the ECM (A30) and the ELD.




12. Check for continuity between ELD 3P connector terminal No.2 and body ground.

Is there continuity?

YES - Go to step 13.

NO - Repair open in the wire between ELD connector terminal No.2 and G202.

13. Reconnect the ELD 3P connector.
14. Start the engine and let it idle.




15. While measuring voltage between ECM/PCM connector terminals A30 and B20, turn the headlights on (low).

Does the voltage drop?

YES - Substitute a known-good ECM/PCM and recheck. If the symptom/indication goes away, replace the original ECM/PCM.

NO - Replace the ELD.