Mirror Holder

Mirror Holder Replacement




1. Pry the mirror holder (A) out from the bottom until you can see the pivot (B) of the actuator, then detach the pivot using a flat-tip screwdriver. Take care not to scratch the mirror(C).




2. Remove the actuator shafts (A) and release the hooks (B) from the actuator (C), then remove the mirror holder (D). If equipped, disconnect the mirror defogger terminals.




3. Remove the actuator shafts (A) and rubber boots (B) from the mirror holder (C). Check the actuator shaft and rubber boot for damage or deterioration, and replace them if necessary.




4. Install the mirror holder in the reverse order of removal, and note these items:
- Before installing the mirror holder, install the actuator shafts and boots on the actuator.
- Apply the grease to the pivot (A) and actuator shafts (B).
- Reattach the mirror holder (C) to the pivot (A) and actuator shafts (B) of the actuator, then carefully push on the pivot and actuator shaft portions of the holder until it locks into place.
- If necessary, before installing the mirror holder, heat the pivot and actuator shafts joint portions of the holder.
- Check the operation of the actuator.