4-Way Power

Front Seat Disassembly/Reassembly - 4-Way Power




SRS components are located in this area. Review the SRS component locations, and precautions and procedures in the SRS section before performing repairs or service.

Disassembly the front sent as shown.
Reassemble the seat in the reverse order of disassembly, and note these items:

- Route the seat wire harness correctly.
- Make sure the bushing and pivot washer are installed correctly.
- Apply multipurpose grease to the moving portion of the seat track.
- To prevent wrinkles in the seat-back cover, stretch the material evenly over the pad.
- If the seat-back pad or the OPDS unit is replaced, reinitialize the OPDS unit. P/N 61S8400.



Front Seat Linkage Disassembly/Reassembly - 4-Way Power






NOTE:
- Put on gloves to protect your hands.
- To remove the slide motor and slide gearbox, slide the front seat backward fully.

Disassemble the linkage as shown.

Reassemble the linkage in the reverse order of disassembly, and note these items:

- Before installing the slide motor and slide gearbox, align portion (A) as shown to align both slide gearbox positions.
- Apply multipurpose grease to the sliding and pivot portions of the linkage.
- Check operation of the recline and slide adjusters.