Removal and Installation

Blower Unit Removal and Installation

SRS components are located in this area. Review the SRS components locations, precautions, and procedures in the SRS section before performing repairs or service.

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the dashboard.
4. With air conditioning; remove the evaporator.




5. Without air conditioning; remove the self-tapping screws, the mounting nut, the mounting bolts and the heater duct.




6. Disconnect the connectors (A) from the blower motor, the blower resistor and the recirculation control motor, then remove the wire harness clip (B). Remove the mounting nuts, the mounting bolt and the blower unit (C).
7. Install the unit in the reverse order of removal, and note these items:
- Make sure that there is no air leakage.
- Enter the anti-theft code for radio, then enter the customer's radio station presets.