SRS Unit Replacement

SRS Unit Replacement

Removal

1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the airbag connectors.
3. Disconnect the side airbag connectors.
4. Remove the center console.




5. Disconnect the connectors (A) from the SRS unit (B).




6. Remove the three Torx bolts (A) from the SRS unit (B), than pull out the SRS unit from the bracket.

Installation




1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit; push it into position until it clicks.

NOTE: When tightening the Torx bolts to the specified torque after replacement, be careful to turn them in so that their heads rest squarely on the brackets.

2. Install the center console.
3. Reconnect the airbag connectors..
4. Reconnect the side airbag connectors.
5. Reconnect the battery negative cable.
6. Initialize the OPDS unit.
7. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about 6 seconds and then go off.