Countershaft Bearing Replacement

Replacement

Special Tools Required
- Adjustable bearing puller, 25 - 40 mm 07736-A01000B
- Driver 07749-0010000
- Attachment, 62 x 68 mm 07746-0010500





1. Remove the retaining plate (A) from the clutch housing (B).





2. Remove the needle bearing (A) using the special tool, then remove the oil guide plate (B).





3. Position the oil guide plate (A) and new needle bearing (B) in the bore of the clutch housing (C).

NOTE: Position the needle bearing with the oil holes (D) facing up.





4. Install the needle bearing (A) using the special tools.





5. Install the retaining plate (A) with new bolts (B) and stake the bolt heads into the groove in the retaining plate.