Standards and Service Limits
| Alternator belt Adjusta new belt to the new belt specification, run the engine for 5 minutes, then readjust it to the used belt specification. | Deflection with 98 N (10 kgf, 22 lbs.) applied midway between pulleys | Without A/C With A/T: See Compressor belt in A/T table | Used belt: 8.5 - 11.0 mm | |
| New belt: 6.5 - 8.5 mm | ||||
| Tension measured with belt tension gauge | Without A/C with A/C see Compressor belt in the A/C table | Used belt: 340 - 490 N | ||
| New belt: 540 - 740 N | ||||
| Alternator | Output | at 13.5 V normal engine temperature | 70A | |
| Coil (rotor) resistance | at 68 deg F (20 deg C) | 1.84 - 2.10 ohms | ||
| Slip ring O.D. | Staandard or new | 22.7 mm | ||
| Service limit | 21.7 mm | |||
| Brush length | Standard or new | 19.0 mm | ||
| Service limit | 5 mm | |||
| Brush spring tension | 3.3 - 4.1 N |