Differential Thrust Clearance Adjustment
Differential Thrust Clearance AdjustmentSpecial Tool Required
Driver, 40 mm I.D. 07746-0030100
1. Install the 80 mm shim that's the same size as the one you removed.
2. Install the differential assembly into the clutch housing.
3. Install the transmission housing onto the clutch housing, then tighten the 8 mm flange bolts in a crisscross pattern in several steps.
8 x 1.25 mm
27 Nm (2.8 kgf-cm, 20 ft. lbs.)
4. Use the special tool to bottom the differential assembly in the clutch housing.
5. Measure clearance between 80 mm shim and bearing outer race in transmission housing with a feeler gauge.
Standard: 0 - 0.10 mm (0 - 0.004 inch)
6. If the clearance is more than the standard, select a new 80 mm shim from the following table. If the clearance measured in step 5 is within the standard go to step 9.
80 mm Shim
7. Remove the bolts and transmission housing.
8. Replace the thrust shim selected in step 6, then recheck the clearance.
9. Reinstall the transmission.